Renishaw A-2275-0192 HPPA 15 inch S/E with RP3 Kit


SKU: A-2275-0192 Category:

Machine Tool Probes | HPPA Standard Kits| HPPA 15 inch S/E with RP3 Kit

This is the HPPA 15 inch S/E with RP3 Kit with A-dimension of 400 and B-dimension of 343

The HPPA (high precision pull-down arm) is a manual ‘pull-down’ ‘push-up’ tool setting system for use on CNC lathes. When needed, the HPPA is manually ‘pulled-down’ into position. After use, the arm is ‘pushed-up’ away from the cutting volume. All HPPA and HPMA systems are supplied with an enclosure to protect the probe and stylus assembly when not in use. HPPA and HPMA hubs are available in both R/E (rear exit ) and S/E (side exit) configurations. S/E hubs are supplied with a fixed 5 m cable. R/E hubs are supplied with a bulkhead connector and require the purchase of a separate cable.


Unidirectional repeatability

max 2σ value in machine XZ axis: 5.0 μm (0.0002 in) for arms supporting 6 in to 15 in chucks
8.0 μm (0.0003 in) for arms supporting 18 in to 24 in chucks

HPPA max arm dimensions: A=555 mm B=458 mm

HPPA min arm dimensions: A=250 mm B=219 mm

HPPA and HPMA are available to fit most common chuck sizes from 6 in to 24 in. Each ‘standard’ kit is supplied complete with:

• Arm

• HPPA or HPMA hub

• RP3 probe (A-2197-0049)

• 90° probe holder

• TSi2 interface for HPPA (A-2176-0010)

• TSi3 interface for HPMA (A-2181-0465)

• Probe enclosure (A-2275-0098)

• Cable (supplied with S/E systems only, purchase separately for R/E systems)